TO THE CONSUMER:Read these and all com-ponent instructions.Please keep for futurereference. Please re-member to return theregistration card.Waranty, r
– 10 –LIMITED WARRANTYThis warranty covers “Bock” Water Heater models 20e, 20pp, 32E, 32EC, 32PP,32PPC, 33E, 33PP, 40E, 40PP, 50ES, 50ESC, 51E, 51EC,
– 11 –BOCK BURNER MODEL/ MAX MODEL MAXMODEL (OIL) MFR.
– 12 –Bock Water Heaters, Inc.110 South Dickinson Street • P.O. Box 8632 • Madison, WI 53708-8632Phone: 608/257-2225 • Fax: 608/257-5304 • www
– 2 –THIS MANUAL HAS BEEN PREPARED TO ACQUAINT YOU WITH THE INSTAL-LATION, OPERATION, AND MAINTENANCE OF YOUR WATER HEATER ANDTO PROVIDE IMPORTANT SAF
The drain valve fitting may be used as an alternate cold water inlet on heatersequipped with a dip tube, as shown inFigure 3. By plumbing a “T” into t
– 4 –Inspect the incoming water line for check valves or water pressure reducingvalves. Any type of check valve may cause pressure to build up in the
– 5 –PLACE THEWATER SYSTEM IN OPERATIONWarning: Handholecover may loosenduring shipping –check for tightnessbefore putting heaterin operation.For any
– 6 –5. While the burner is operating, disconnect one of the yellow cad cell wires.Check to see that the burner control locks out in the time specifie
– 7 –SERVICE1. Check the fuel supply, electrical wiring and fuses, and make sure temperaturecontrol is calling for heat.2. If the motor runs but there
L4080BL4006AFIGURE 8: Honeywell L4006A w/ L8080BFor Models: 50, 120EFIGURE 6: Beckett or Wayne burner w/ Carlin EZ-TempFor Models: 32, 33, 40, 50, 51,
– 9 –ITEM DESCRIPTION 1. Cold Water Inlet Dip Tube (N/A 33E & 40E)2. Plastic Cap 3. Magnesium Anode Rod (aluminum avaliable
Commentaires sur ces manuels